数字音视工程网

微信公众号

数字音视工程网

手机DAV

null
null
null
null
null
null
null
null
null
null
null
null
null
null
艾索
null
null
null
null
null
招商,
null

我的位置:

爱思创Extron电子-用于 HDMI 信号的 DTP 发送器 - Decorator 型墙面板-DTP T HWP 4K 231 D

厂家报价:面议 产品状态:(在产)

用于 HDMI 信号的 DTP 发送器 - Decorator 型墙面板 DTP T HWP 4K 231 D

产品品牌: 爱思创EXTRON
产品类别: 产品中心
咨询 加入收藏 我要评价
咨询
所在单位:*
姓名:*
手机:*
职位:
邮箱:*
其他联系方式:
咨询内容:
验证码:
不能为空 验证码错误
确定
爱思创电子(上海)有限公司_爱思创Extron中国

厂商介绍: 爱思创电子(上海)有限公司(爱思创Extron中国)全球总部位于美国加州,是世界领先的专业视音频系统集成产品的生产商。爱思创Extron产品主要包括视音频控制系统、计算机视频接口、切换器、矩阵切换器、分配放大器、音频放大器、扬声器、双绞线和光纤设备、视频图像解析度转换器、视音频信号处理器、视音频流媒... [详细]

经销商 联系方式 价格
爱思创Extron电子 4000.398766、 021-3760 1568 面议
DTP T HWP 4K 231 D

specifications
Frame rate 1 24, 25, 30, 50, or 60 fps
Chroma sampling 1 4:4:4, 4:2:2, or 4:2:0
Color bit depth 1 8 bits per color
Signal type HDMI 1.4, HDCP 2.2
Max. video data rate 10.2 Gbps (3.4 Gbps per color)
NOTE 1 Subject to the maximum data rate limit. Use our calculator at www.extron.com/4Kdatarate to determine video parameters supported by this data rate.
Video
Maximum data rate 10.2 Gbps (3.4 Gbps per color)
Maximum pixel clock 300 MHz
Resolution range Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz,
4K/UHD @ 60 Hz with 4:2:0 chroma subsampling
(*Reduced blanking)
Color bit depth 8, 10, or 12 bits — subject to the maximum data rate limit
Formats RGB and YCbCr digital video
Standards DVI 1.0, HDMI 1.4, HDCP 2.2, CEA-861E
Video input
Number/signal type 1 single link HDMI (or DVI-D * ) input
Connectors 1 female HDMI type A
NOTE * AppropriateHDMI to DVI-D cables or adapters are required for HDMI signal input/output.
Interconnection between transmitter and receiver
Connectors 1 female RJ-45 per unit for 1 cable connecting the transmitter and receiver
Termination standards TIA/EIA T568B
DTP signal
Signal transmission distance
1080p @ 60 Hz Up to 230' (70 m) using shielded twisted pair (STP) cable or XTP DTP 24 cable
2560x1600 @ 60 Hz Up to 130' (40 m) using STP cable or XTP DTP 24 cable
4K/UHD @ 30 and 60 Hz Up to 130' (40 m) using STP cable or XTP DTP 24 cable
Cable requirements Solid conductor, 24 AWG or better
Cable recommendations 400 MHz bandwidth STP cable
NOTE Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.
NOTE Output mode signaling:
DTP: HDMI with embedded audio, analog audio, RS-232 and IR, and remote power
HDBaseT: HDMI with embedded audio plus RS-232 and IR
Audio
Gain Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response 20 Hz to 20 kHz, ±0.5 dB
THD + Noise 0.03% @ 20 Hz to 20 kHz at maximum output
S/N >90 dB at maximum output (15 dBu), balanced (unweighted)
Stereo channel separation >80 dB @ 1 kHz to 20 kHz
Audio input
Number/signal type 1 stereo (2 channel), unbalanced
NOTE Analog audio is not embedded onto the digital video signal. Analog audio and digital embedded audio are transmitted simultaneously and output on the receiver on two different connectors.
Connectors (1) 3.5 mm stereo jack, 2 channel; tip (L); ring (R); sleeve (ground)
Impedance >10k ohms, DC coupled
Nominal level -10 dBV (316 mVrms)
Maximum level +7 dBV, unbalanced
NOTE 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Communications — external device (RS-232/IR over TP)
Serial control port RS-232 via (1) 3.5 mm, 5 pole captive screw connector<BR>(connector is shared with IR control port)
NOTE Protocol is mirrored between the connected DTP 230 or DTP 330 endpoints and the "Over TP" ports on the
DTP T HWP 231 D. Signals from a control device pass into each "Over TP" port, are embedded with the DTP signal, and sent to the individual DTP 230 Tx or Rx endpoints for control of remote sink or source devices. The "Over TP" ports are simply pass-through connections to DTP endpoints.
Baud rates Up to 115200 baud
Protocol Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none
Serial control pin configuration Captive screw connectors: 1 = Tx, 2 = Rx, 3 = Gnd
IR control port (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port)
TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz
IR control pin configuration 3 = Gnd, 4 = IR Tx, 5 = IR Rx
General
Power supply External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC,1.5 A, 18 watts
Power consumption
Device 4.6 watts, 12 VDC
Device and power supply 6.1 watts, 100-240 VAC, 50-60 Hz
NOTE Each transmitter or receiver can be powered either locally by an external power supply or remotely by receiver or transmitter on the other end of thetwisted paircable.
Temperature/humidity Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling Convection, no vents
Thermal dissipation
Device 14.3 BTU/hr
Device and power supply 19.7 BTU/hr
Mounting
Furniture or wall mount Yes, with a 1-gang wall box or mud ring
Enclosure type Metal
Enclosure dimensions
Faceplate 2.6" H x 1.3" W x 0.3" D
(6.6 cm H x 3.3 cm W x 0.6 cm D)
Device 2.8" H x 1.7" W x 1.9" D
(7.1 cm H x 4.3 cm W x 4.8 cm D)
NOTE Overall height is 4.2" (10.7 cm), including mounting tabs. Mounting holes are 3.2" (8.2 cm) apart on center.
Depth excludes connectors. Fits the opening in a 1 gang decorator wallplate).
Product weight 0.2 lbs (0.1 kg)
Regulatory compliance AN/NZS, c-UL, C-tick, CE**, FCC Class A**, ICES, UL
NOTE **CE and FCC testing is conducted with STP cable.
Product warranty 3 years parts and labor
Everlast power supply warranty 7 years parts and labor
NOTE All nominal levels are at ±10%.
NOTE Specifications are subject to change without notice.
NOTE Shipping dimensions and weights are available at www.extron.com .
(4455-092818)
    null