我的位置：
爱思创Extron电子-用于 DVI 信号的 DTP 发送器 - Decorator 型墙面板-DTP DVI 4K 230 D Tx
厂家报价：面议
产品状态：(在产)
用于 DVI 信号的 DTP 发送器 - Decorator 型墙面板 DTP DVI 4K 230 D Tx
产品品牌：
爱思创EXTRON
产品类别：
产品中心
地址：中国上海市松江区茸华路 686 号
电话：4000.398766、 021-3760 1568(联系就说在DAV音视工程网上看到的)
| 经销商 | 联系方式 | 价格 |
|---|---|---|
| 爱思创Extron电子 | 4000.398766、 021-3760 1568 | 面议 |
| DTP DVI 4K 230 D Tx/Rx | |||
 specifications |
|||
|---|---|---|---|
 |
|||
| Frame rate 1 | 24, 25, 30, 50, or 60 fps | ||
| Chroma sampling 1 | 4:4:4, 4:2:2, or 4:2:0 | ||
| Color bit depth 1 | 8 bits per color | ||
| Signal type | HDMI 1.4, HDCP 2.2 | ||
| Max. video data rate | 10.2 Gbps (3.4 Gbps per color) | ||
|
|||
| Video | |||
| Maximum data rate | 10.2 Gbps (3.4 Gbps per color) | ||
| Maximum pixel clock | 300 MHz | ||
| Resolution range | Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling (*Reduced blanking) |
||
| Color bit depth | 8, 10, or 12 bits — subject to the maximum data rate limit | ||
| Formats | RGB and YCbCr digital video | ||
| Standards | DVI 1.0, HDMI 1.4, HDCP 2.2 | ||
| Video input and loop through — transmitter | |||
| Number/signal type | 1 single link DVI-D (or HDMI * ) input 1 single link DVI-D (or HDMI * ) local loop-through |
||
| Connectors | 2 female DVI-I | ||
|
|||
| Interconnection between transmitter and receiver | |||
| Connectors | 1 female RJ-45 per unit for 1 cable connecting the transmitter and receiver | ||
| Termination standards | TIA/EIA T568B | ||
| DTP signal | |||
| Signal transmission distance | |||
| 1080p @ 60 Hz | Up to 230' (70 m) using shielded twisted pair (STP) cable or XTP DTP 24 cable | ||
| 2560x1600 @ 60 Hz | Up to 130' (40 m) using STP cable or XTP DTP 24 cable | ||
| 4K/UHD @ 30 and 60 Hz | Up to 130' (40 m) using STP cable or XTP DTP 24 cable | ||
| Cable requirements | Solid conductor, 24 AWG or better | ||
| Cable recommendations | 400 MHz bandwidth STP cable | ||
|
|||
| Video output — receiver | |||
| Number/signal type | 1 single link DVI-D (or HDMI*) | ||
| Connectors | 1 female DVI-I | ||
| Audio | |||
| Gain | Unbalanced output: 0 dB | ||
| Frequency response | 20 Hz to 20 kHz, ±1 dB | ||
| THD + Noise | 0.03% @ 1 kHz at nominal level, 0.3% @ 20 kHz at nominal level | ||
| S/N | >90 dB, at maximum output (unweighted) | ||
| Stereo channel separation | >80 dB @ 1 kHz to 20 kHz | ||
| Audio input — transmitter | |||
| Number/signal type | 1 PC level stereo, unbalanced | ||
|
|||
| Connectors | (1) 3.5 mm stereo jack, 2 channel; tip (L); ring (R); sleeve (ground) | ||
| Impedance | 20k ohms, DC coupled | ||
| Nominal level | -10 dBV (316 mVrms) | ||
| Maximum level | +6 dBu, unbalanced | ||
|
|||
| Audio output — receiver | |||
| Number/signal type | 1 stereo (2 channel), unbalanced | ||
| Connectors | (1) 3.5 mm stereo jack, 2 channel; tip (L), ring (R), sleeve (ground) | ||
| Impedance | 50 ohms, unbalanced | ||
| Gain error | ±0.2 dB channel to channel | ||
| Maximum level (600 ohm) | >+7 dBu, unbalanced at 1% THD+N | ||
| Control/remote — external device (pass-through, unidirectional or bidirectional) | |||
| Serial control port input | |||
| Transmitter | RS-232 via (1) 3.5 mm, 5 pole captive screw connector (connector is shared with IR control port) |
||
| Receiver | 1 set of proprietary signals on a female RJ-45 jack | ||
| Serial control port output | |||
| Transmitter | 1 set of proprietary signals on a female RJ-45 jack | ||
| Receiver | RS-232 via a 3.5 mm, 5 pole captive screw connector | ||
|
|||
| Baud rate and protocol | 300 to 115200 baud, 8 or 7 data bits, 1 or 2 stop bits, non-parity (default), even or odd parity | ||
| Serial control pin configuration | Captive screw connectors: 1 = Tx, 2 = Rx, 3 = Gnd | ||
| IR control port | (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz |
||
| IR control pin configuration | 3 = Gnd, 4 = IR Tx, 5 = IR Rx | ||
| General | |||
| Power supply | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC,1.5 A, 18 watts |
||
| Power consumption | |||
| Transmitter | |||
| Device | 3.3 watts, 12 VDC | ||
| Device and power supply | 4.6 watts, 100-240 VAC, 50-60 Hz | ||
| Receiver | |||
| Device | 4.3 watts, 12 VDC | ||
| Device and power supply | 5.9 watts, 100-240 VAC, 50-60 Hz | ||
|
|||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
||
| Cooling | Convection, no vents | ||
| Thermal dissipation | |||
| Transmitter | |||
| Device | 9.9 BTU/hr | ||
| Device and power supply | 14.5 BTU/hr | ||
| Receiver | |||
| Device | 13.3 BTU/hr | ||
| Device and power supply | 19.0 BTU/hr | ||
| Mounting | |||
| Furniture or wall mount | Yes, with a 2-gang wall box or mud ring | ||
| Enclosure type | Metal | ||
| Enclosure dimensions | |||
| Faceplate | 2.6" H x 2.6" W x 0.1" D (6.6 cm H x 6.6 cm W x 0.3 cm D) (Fits the opening in a 2-gang decorator wallplate.) |
||
| Device | 2.8" H x 3.5" W x 1.7" D (7.1 cm H x 8.9 cm W x 4.3 cm D) |
||
|
|||
| Product weight | 0.4 lbs (0.2 kg) | ||
| Regulatory compliance | c-UL,C-tick,CE**, FCC Class A**, ICES, KC, UL, VCCI | ||
|
|||
| Product warranty | 3 years parts and labor | ||
| Everlast power supply warranty | 7 years parts and labor | ||
|
|||
|
|||
|
|||
| (4383-092818) | |||
