我的位置:
经销商 | 联系方式 | 价格 |
---|---|---|
爱思创Extron电子 | 4000.398766、 021-3760 1568 | 面议 |
TLP Pro 1520MG | |||
Display | |||
---|---|---|---|
Screen type | Active matrix TFT color display | ||
Size | 15.6" (39.5 cm), measured diagonally | ||
Resolution | 1366x768 | ||
Dot/pixel pitch | 100 dpi | ||
Aspect ratio | Widescreen | ||
Color depth | 24-bit, 16.7M colors | ||
Transparency | 8 bit alpha channel | ||
Brightness | 270 nits (cd/m 2 ) | ||
Contrast | 475:1 | ||
Backlight | LED | ||
Viewing angle | ±85° horizontal, ±80° vertical | ||
Touch screen | Capacitive | ||
Memory | |||
SDRAM | 512MB | ||
Flash | 512 MB | ||
XTP – Interconnection between transmitter and receiver | |||
Termination standard | TIA/EIA T568A or T568B | ||
Signal transmission distance | 330' (100m) using CAT 5e/6/7 UTP or STP cable (24 AWG or better) | ||
Cable requirements | Solid conductor, 24 AWG or better | ||
Cable recommendations | 400 MHz bandwidth, STP (Shielded Twisted Pair) | ||
Video input | |||
Resolution range | Up to 1920x1200*, 2K, or 1080p (HDTV) * reduced blanking |
||
Number/signal type | 1 HDMI (HDCP compliant) 1 XTP |
||
Connectors | 1 female HDMI type A 1 female RJ-45 (shared with Ethernet interface) |
||
Horizontal frequency | 18.75 kHz to 75 kHz | ||
Vertical frequency | 24 Hz to 75 Hz | ||
Standards | DVI 1.0, HDMI, HDCP | ||
Audio sampling rate | 48 kHz | ||
Video processing | |||
HDMI pixel data bit depth | 8, 10, or 12 bits per channel; 165 MHz pixel clock | ||
Colors | 1 billion (10 bit processing) | ||
Control — Touchpanel | |||
Motion sensor | On/off | ||
Light sensor | On/off | ||
Control – Ethernet interface | |||
Ethernet control/communications port | 1 female RJ-45 connector (shared with XTP video input) | ||
Ethernet data rate | 100Base-T, half/full duplex with autodetect | ||
Protocol | DHCP, DNS, HTTP, HTTPS, ICMP, SFTP, SSH, TCP/IP, UDP/IP | ||
Default settings | Link speed and duplex level: autodetected IP address = 192.168.254.251 Subnet mask = 255.255.0.0 Default gateway = 0.0.0.0 DHCP = off DNS = 127.0.0.1 |
||
Software | |||
Configuration software | Global Configurator Plus and Professional, GUI Designer | ||
Programming software | Global Scripter | ||
Control apps | Extron Control, iGVE | ||
Resource management software | GlobalViewer Enterprise, iGVE | ||
Utilities | Toolbelt, Embedded Web page | ||
Control — Host ports | |||
Number/signal type | 2 high-speed USB 2.0 devices | ||
Connectors | 2 USB type A connectors | ||
USB standards | USB 2.0, USB 1.1, USB 1.0 compatible | ||
USB data rates | Low speed (1.5 Mbps), full speed (12 Mbps) | ||
Audio output – Speaker | |||
Speaker output | 2speakers (stereo), 86 dB SPL, 0.1 watt, 0.1 m, half space | ||
Frequency response | 750 Hz to 20 kHz, ±5 dB | ||
Playback format(s) | |||
Container format | WAV (Microsoft RIFF) | ||
Encoding | LPCM (uncompressed) | ||
Bit depth | Unsigned 8-bit, Signed 16-bit, Signed 24-bit, Signed 32-bit | ||
Sampling rate | 2 kHz to 192 kHz | ||
Audio channels | Mono or stereo | ||
Audio output – Line level | |||
Number/signal type | 1 stereo, unbalanced | ||
Connectors | 1 female 3.5 mm stereo mini jack; tip (L), ring (R), sleeve (GND) | ||
Impedance | 50 ohms unbalanced | ||
Gain error | ±0.1 dB channel to channel | ||
Nominal level | -10 dBV (316 mVrms) | ||
Maximum level (Hi-Z) | >+8.2 dBV unbalanced at 1% THD+N | ||
Maximum level (600 ohm) | >7.1 dBm unbalanced at 1% THD+N | ||
General | |||
Power supply | Not included | ||
Power input requirements | 12 VDC or Power over Ethernet Plus (PoE+ IEEE 802.3at) |
||
Power consumption — Power injector (PI 140) | |||
Device | 26.7 watts | ||
Device and power injector | 30.9 watts | ||
Power consumption — PoE + PSE | |||
Device | 23.5 watts | ||
Power consumption — Power supply (PS 1230) | |||
Device | 23.2 watts | ||
Device and power supply | 29.6 watts | ||
Temperature/humidity | Storage:-4 to +140 °F (-20 to +60 °C) / 10% to 90%, noncondensing Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing |
||
Cooling | Convection, vents on top, bottom, and rear | ||
Thermal dissipation — Power injector (PI 140) | |||
Device | 86.0 BTU/hr | ||
Device and power injector | 101.0 BTU/hr | ||
Thermal dissipation — PoE + PSE | |||
Device | 75.0 BTU/hr | ||
Thermal dissipation — Power supply (PS 1230) | |||
Device | 73.8 BTU/hr | ||
Device and power supply | 95.9 BTU/hr | ||
Mounting | |||
Rack mount | With optional kit | ||
Furniture or wall mount | With included hardware or optional accessories | ||
Enclosure type | Plastic | ||
![]() |
|||
Enclosure dimensions | |||
Faceplate | 11.0"H x16.1" Wx 1.1" D (280 mm Hx 408 mm W x29 mm D) |
||
Enclosure | 5.6" H x8.8" W x1.6" D (142 mm H x224 mm W x41 mm D) |
||
Product weight | 7.0 lbs (3.18 kg) | ||
Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
Regulatory compliance | |||
Safety | CE, c-UL, UL | ||
EMI/EMC | CE, C-tick,FCC ClassA, ICES, VCCI | ||
Environmental | Complies with theappropriate requirements of RoHS and WEEE. | ||
Product warranty | 3 years parts and labor; touchpanel display and overlay components are covered for 1 year | ||
|
|||
|
|||
|
|||
(4046_D8_053117) |