数字音视工程网

微信公众号

数字音视工程网

手机DAV

null
null
null
null
null
null
null
null
null
null
null
null
null
null
艾索
null
null
null
null
null
招商,
null

我的位置:

爱思创Extron电子-用于 VGA、视频、音频和 RS-232 信号并带扭曲延时均衡的通用型 MTP 双绞线接收器-MTP U R RSA SEQ

厂家报价:面议 产品状态:(在产)

用于 VGA、视频、音频和 RS-232 信号并带扭曲延时均衡的通用型 MTP 双绞线接收器 MTP U R RSA SEQ

产品品牌: 爱思创EXTRON
产品类别: 产品中心
咨询 加入收藏 我要评价
咨询
所在单位:*
姓名:*
手机:*
职位:
邮箱:*
其他联系方式:
咨询内容:
验证码:
不能为空 验证码错误
确定
爱思创电子(上海)有限公司_爱思创Extron中国

厂商介绍: 爱思创电子(上海)有限公司(爱思创Extron中国)全球总部位于美国加州,是世界领先的专业视音频系统集成产品的生产商。爱思创Extron产品主要包括视音频控制系统、计算机视频接口、切换器、矩阵切换器、分配放大器、音频放大器、扬声器、双绞线和光纤设备、视频图像解析度转换器、视音频信号处理器、视音频流媒... [详细]

经销商 联系方式 价格
爱思创Extron电子 4000.398766、 021-3760 1568 面议
MTP U R Series
Video
Gain Unity
Video input
Number/signal type 1 set of proprietary analog signals
Connectors 1 female RJ-45
Video output
Number/signal type 1 RGBHV, RGBS, component video (bi-level and tri-level), S-video, composite video (follows input type)
Connectors
MTP U R RSA SEQ, MTP C7 U R RSA SEQ 1 female 15-pin HD for RGB
3 female BNC for Y, R-Y, B-Y
1 female4-pin mini DIN for S-video (Y/C)
1 female BNC for composite video
All other models 1 female 15-pin HD for RGB or Y, R-Y, B-Y
1 female4-pin mini DIN for S-video (Y/C)
1 female BNC for composite video
Nominal level 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels 0.8 V to 1.2 Vp-p
Impedance 75 ohms (during video output only)
Return loss <-30 dB @ 5 MHz (during video output only)
DC offset <±20 mV with input at 0 offset
Skew compensation 62 ns
Maximum resolution Up to 1920x1200 or 2048x1080 or 1080p at 300'
Up to 1024x768 at 600'
NOTE Refer to the user's guide for the maximum distances recommended for specific resolutions.
Sync
Output type RGBHV, RGBS
Standards NTSC 3.58, NTSC 4.43, PAL, SECAM
Output level 4.0 V to 5.0 Vp-p, unterminated
Output impedance 87 ohms (24 mA)
Polarity Positive or negative (selectable)
Audio — MTP U R RSA SEQ, MTP U R A, MTP C7 U R RSA SEQ
Gain Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response 20 Hz to 20 kHz, ±1 dB
THD + Noise 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level
S/N >70 dB at maximum output (unweighted)
Audio input — MTP U R RSA SEQ, MTP U R A, MTP C7 U R RSA SEQ— See MTP Series transmitters' audio output specifications
Number/signal type 1 set of proprietary analog signals
Connectors 1 female RJ-45
NOTE 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output — MTP U R RSA SEQ, MTP U R A, MTP C7 U R RSA SEQ
Number/signal type 2 mono, balanced/unbalanced
Connectors (1) 3.5 mm captive screw connector, 5 pole
Impedance 50 ohms unbalanced, 100 ohms balanced
Gain error ±1 dB channel to channel
Control/remote — external device (pass-through, unidirectional or bidirectional) (RS and RSA models)
Serial control port input/output RS-232 via (1) 3.5 mm, 3 pole captive screw connector
Baud rates Up to 38400 bps at up to 600' (183 m)
NOTE Higher data rates and distances are possible. Performance varies based on baud rate and cable length.
Protocol Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none
NOTE Protocol is mirrored between the transmitter and the receiver.
Serial control pin configuration Captive screw connectors: 1 = Tx, 2 = Rx, 3 = GND
General
Recommended cable type
MTP C7 U R RSA SEQ CAT 7 (shielded) or Extron STP201
All other models CAT 5/5e/6 (shielded or unshielded)
NOTE Shielded twisted pair cable provides added protection from outside interference and increases overall signal transmission distance. Extron strongly recommends using shielded twisted pair for optimal performance.
Power supply External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 watts
Power input requirements 12 VDC, 0.5 A
Temperature/humidity Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling Convection, vents on top and sides
Mounting
Rack mount Yes, with optional 1U rack shelf
Furniture mount Yes, with optional mini under-desk mounting kit
Pole mount Yes, with optional pole mounting kit
Enclosure type Metal
Enclosure dimensions 1.7" H x 4.3" W x 3.0" D (1U high, quarter rack wide)
(4.3 cm H x 10.9 cm W x 7.6 cm D)
(Depth excludes connectors.)
Product weight 0.6 lbs (0.3 kg)
Shipping weight 2 lbs (1 kg)
Vibration ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety CE, c-UL, UL
EMI/EMC CE, C-tick, FCC Class A, ICES, VCCI
Product warranty 3 years parts and labor
NOTE All nominal levels are at ±10%.
NOTE Specifications are subject to change without notice.
(8.0-060811-D11)
    null